After the automatic palletizing machine is started, if it operates normally in the transposition process, but consecutive times when the material belt reaches the transposition position, the transposition does not stop running and the transposition machine does not have the fault of bag clamping and transposition, then the technicians need to check whether the transposition photoelectric switch is abnormal. If it occurs once, it may be caused by a counting error.
When the automatic palletizing machine is in operation, if the transfer mechanism stops running and the transfer machine fails to hold the bags, this fault may occur on the electro-magnetic valve or the cylinder of the palletizing machine. In this case, technicians should conduct a focused inspection of the electro-magnetic valve and the cylinder, and promptly repair or replace the electro-magnetic valve and the cylinder.
If the transposition machine fails to perform the transposition after bagging, and the transposition machine has completed the transposition and the clamping plate has opened, but the transposition machine does not rotate and the transposition conveyor does not operate either, then the technicians should first check whether the position detection switch of the automatic palletizer is conducting normally. If this switch conducts normally, the fault might be caused by abnormalities in the motor and control circuit.
If the automatic palletizing machine has problems with incorrect positioning after operating for a period of time, the positioning is correct switch can be used to adjust. If it is servo positioning that is incorrect, the rotation angle can be adjusted through the driver. For cylinder positioning, the angle can be adjusted by adjusting the cylinder speed and the positioning position.
