(1) before starting the belt conveyor should first check the tightness of the belt machine, should not be too tight, so as not to weaken the strength of the joint: also can not be too loose, causing the belt to slip, damage the belt and reduce the amount of conveyor.
(2) Power on, should be no load start, to operate normally, then start feeding.
Before stopping the machine, stop the material supply first. After unloading the material on the conveyor belt, turn off the motor and cut off the power supply.
When several conveyors are connected head to tail and work together, the boot procedure should be from back to front, and finally start the first conveyor, and start feeding.
The sequence of stops is just the opposite of starting up.
In the work, if a fault occurs in the middle of a conveyor, the first conveyor should be stopped to make the feeding stop, and then the faulty conveyor and the rest of the machine will be separated.
(3) Feeding should be uniform, the material should be appropriate, the material should be fed to the middle of the belt conveyor belt, to prevent going unilateral.
When conveying materials into bags, they should also be placed in the middle of the conveyor belt to avoid the bag being hooked by the machine and causing damage.
(4) Often check the lubrication of transmission parts, lubricating oil, grease.
If the conveyor belt is found damaged, it should be repaired in time and replaced immediately in case of serious damage, so as not to cause loss and waste of materials and affect the normal operation of conveying.
6 conveyor belt belongs to rubber products, in use and storage should prevent contact with lubricating oil, gasoline and diesel oil, so as not to erode and deteriorate, affect the service life.
7 belt conveyor not in use should be covered with oilcloth, to avoid the night dew and rain so that the conveyor belt aging deterioration, frame corrosion deformation.
In order to ensure the normal operation of the conveyor, to extend the service life, under normal circumstances should be carried out an annual overhaul.
When repairing the belt conveyor, first remove the guide trough, protective cover and transmission parts, and then remove the conveyor belt, and then remove the upper and lower rollers and rollers.
After cleaning and repairing the removed parts,
Add sufficient lubricating oil and grease to the bearing area, and then install and adjust the steps of installation and disassembly are opposite.
